Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

A question on coverage merge

Status
Not open for further replies.
T

tarkyss

Full Member level 6
Joined
Aug 1, 2005
Messages
340
Helped
26
Reputation
52
Reaction score
8
Trophy points
1,298
Location
China
Activity points
4,162
I use nc-sim to verify our design,
when I merge lots of coverage test results, an error occurred
"failed due to mismatch in design checksum with the loaded model file"
the reason maybe the dut is a bridge, in each time, different slave is used to test,
could i merge coverage lick that?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top