Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Time division multiplexing

Status
Not open for further replies.
S

sundarmeenakshi

Full Member level 3
Joined
Dec 12, 2006
Messages
188
Helped
19
Reputation
38
Reaction score
2
Trophy points
1,298
Activity points
2,258
IN a Asynchronous TDM sysem out of 200 sources only 30 sources are active at a time as the input sources can generate data at a different rate, the time slots can have variable length of 1 nsec to 16 n sec. Calculate the over head bits added in every slot?

Dear friends any on can help to find the ans for this.
 

it depends on the system... they have a number of bits to identify the source and which in your case would be 7bits and if there are bits added for error correction then the number of overhead bits could be higher.... also a stream of bits are required to inform the receiver that the particular transmitter has finished transmitting...
 
A.Anand Srinivasan said:
it depends on the system... they have a number of bits to identify the source and which in your case would be 7bits and if there are bits added for error correction then the number of overhead bits could be higher.... also a stream of bits are required to inform the receiver that the particular transmitter has finished transmitting...
Click to expand...

i think it is 5 bits.
n=log base2 to the power of 30.
 

you are supposed to have identity values for all the 200 sources because you dont know which 30 sources are transmitting currently....
 
A.Anand Srinivasan said:
you are supposed to have identity values for all the 200 sources because you dont know which 30 sources are transmitting currently....
Click to expand...
then also 8 bits na?
this variable time slot has no effect in the no of bits? i need ans for tis also.
 

oh sorry... it is 8 bits only... i wrongly calculated using 120 sources.... actually overhead bits is the bits other than the message bits and this normally includes the source id, a sequence to denote the starting and stopping of transmission from a source since the transmission is asynchronous and also some error correcting codes....
the start and stop bits is compulsory since the transmission is asynchronous....
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top