Junaid151
Junior Member level 2
Hi everyone,
I am an absolute newbie here and want to design a Klofenstein taper using a microstrip fabrication
Z1=15,
Z2=50Ohm,
starting frequency is 1.5GHz assuming until 20GHz
S11<-15dB
These are the specifications of the design.
Now I have found a very useful website which has been alot of
help
**broken link removed**
However what I want to know is how to use this frequency in my design I mean the impedance transformer will only work at the specified frequency band, but how to use the frequency to calculate the lenght?
Please any help will be greatly appreciated.
I am an absolute newbie here and want to design a Klofenstein taper using a microstrip fabrication
Z1=15,
Z2=50Ohm,
starting frequency is 1.5GHz assuming until 20GHz
S11<-15dB
These are the specifications of the design.
Now I have found a very useful website which has been alot of
help
**broken link removed**
However what I want to know is how to use this frequency in my design I mean the impedance transformer will only work at the specified frequency band, but how to use the frequency to calculate the lenght?
Please any help will be greatly appreciated.