Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Calibre drc error: failure to read input file stdin at record offset 0

Status
Not open for further replies.
L

lsf0201

Newbie level 1
Joined
Jul 21, 2010
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,290
Hi

i am working at the final stage verification and run drc , I calibre ends with exit error and says.


ERROR: Failure to read input file stdin at record offset 0.


can some one tell me .. wat could be the possible mistake i am doing

** I use layout file *.oa

thank you in advance

lsf0201
 

Re: calibre drc error

Hi lsf0201:
i encontered the same problem,have you solved it?
 

Hello,

I think you are running design using mentor rule file. This error you are seeing if you have set wrong variable. I mean in case of oasis data, rule file should export the LAYOUT SYSTEM = OASIS while running the deck, if it is exporting LAYOUT SYSTEM =GDS then it would give this kind of error message.

Generally this would be controlled by some switch setting being used in rule file. You just need to set correct switch setting.

Hope this helps.

Bye,
 
What is the error message you are getting ? Generally the error message mentioned above reports only when you have export wrong setting like in case of running rule file on gds data you have used LAYOU_SYSTEM = OASIS...
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top