Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] 3.3 volts on PIC microcontroller.

Status
Not open for further replies.
M

mr_anderson

Advanced Member level 4
Joined
Jan 23, 2007
Messages
100
Helped
5
Reputation
10
Reaction score
4
Trophy points
1,298
Activity points
2,005
Hi
I have a 5 volt 2 Mhz signal that is being generated by PIC18F87J60 and PIC16F877A, I am trying to feed that signal to a take an input of 3.3 volts. The problem is the 5 to 3.3 volt converter will take 7 days to arrive so I am trying to come up with a quick solution.

I went through the data sheet of 87J60 and found that it has some 3.3 volts feature but didn't really understand is that for ethernet only or I can have 3.3 on all the pins?

I also tried to connect 4 diodes in series with one 4.7K resistor to get a voltage drop from 5 to less than 3 volts but that is giving some noisy results, any suggestions will be highly appreciated.

Thx.
 

How about a voltage divider? Also, 4 diodes will give you about 2.8V of drop; add to that the IR drop of your resistor might take your voltage out of range. Just because your device is running off of 5 Volts doesn't mean your OUTPUT is 5V. Have you looked at your signals with a scope?
 

try a resistor voltage divider

what type of diodes did you use?
 

I dont understand : your PIC18F87J60 supports max 3.6V : how can it generate a 5V signal ?
replace the 16f477 with a xxLFxxx pic so it supports 3V and power all your project with 3V
would be the most effective way to do this
but in a hurry, I think like the others a simple voltage divider with 2 resistors would do the trick.
 
:!:
use a simple resistor divider

Code: 
for output 
5V level ------ 1.5 K -----|-------> 3,3 LEVEL
                                   |
                                 2,2K
                                   |
----------------------------|----------Gnd
and direct link in other way 3,3V out --> direct to 5V TTL input

sorry, i don't know how to manage spaces , even with CODE balises or ???
2,2K is between 3,3V output and ground..
 
Last edited:
Thank you guys very much.
U are right about the 87J60 it uses 3.3 but apparently the board that I am using had a 3.3 to 5 converter. This is why I was seeing the 5 voltage. Thank you again for pointing that out.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top