Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

intersecion problem objects coax and coax pin

Status
Not open for further replies.
P

Preeti Rani

Newbie level 3
Joined
Sep 9, 2013
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
23
hi, i am having a problem regarding hfss model that an error exists of intersection of objects coax and coax pin as shown in figure below.
and i dont find any way to stop this intersection between them.
i am having the coax of air and coax pin of pec material.could any one help me regarding this.
thanks and regard
preeti Untitled.png
 

Welcome Preeti Rani ,

The standard way to do this is to subtract the pin from the air. Be sure to check the "clone tool parts" before you do the subtraction.

Good Luck

Rudri890@gmail.com said:
ooooooooooooooooooooooooooo:(
Click to expand...

Seriously, that's your first post?
 
Hi Preeti Rani!
I hope this file help you.It is a monopole antenna that is excited by a coaxial cable.
you can use from it's coax section.
*ghasem*
 

Attachments

  • monopole_ghasem_sadeghi.zip
    24 KB · Views: 116
Preeti Rani said:
hi, i am having a problem regarding hfss model that an error exists of intersection of objects coax and coax pin as shown in figure below.
and i dont find any way to stop this intersection between them.
i am having the coax of air and coax pin of pec material.could any one help me regarding this.
thanks and regard
preetiView attachment 97576[/QU



there is two method...
1st: go to HFSS>design setting > and click yes to override material...
2nd: subtract inner conductor with outer one ....don't forget cloning...
Click to expand...
 
thank you so much for your help regarding my problem ..................................:):idea::grin:
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top