intersecion problem objects coax and coax pin

[Preeti Rani]

hi, i am having a problem regarding hfss model that an error exists of intersection of objects coax and coax pin as shown in figure below.
and i dont find any way to stop this intersection between them.
i am having the coax of air and coax pin of pec material.could any one help me regarding this.
thanks and regard
preeti

 

[Rudri890@gmail.com]

ooooooooooooooooooooooooooo

 

[PlanarMetamaterials]

Welcome Preeti Rani ,

The standard way to do this is to subtract the pin from the air. Be sure to check the "clone tool parts" before you do the subtraction.

Good Luck

ooooooooooooooooooooooooooo

Seriously, that's your first post?

 

[ghasem_008]

Hi Preeti Rani!
I hope this file help you.It is a monopole antenna that is excited by a coaxial cable.
you can use from it's coax section.
*ghasem*

 

[pradeep_svnit]

hi, i am having a problem regarding hfss model that an error exists of intersection of objects coax and coax pin as shown in figure below.
and i dont find any way to stop this intersection between them.
i am having the coax of air and coax pin of pec material.could any one help me regarding this.
thanks and regard
preetiView attachment 97576[/QU



there is two method...
1st: go to HFSS>design setting > and click yes to override material...
2nd: subtract inner conductor with outer one ....don't forget cloning...

 

[Preeti Rani]

thank you so much for your help regarding my problem ..................................:idea::grin: