Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] rf transmitter and receiver 433mhz problem

Status
Not open for further replies.
A

Aravindh RS

Newbie level 3
Joined
Oct 16, 2013
Messages
4
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Location
India
Activity points
27
my leds seem to be glowing always irrespective of the switch's toggle
if anybody can help me out!!!! :-(
plzzzzzzz :) :)
 

DSCN0007.JPGrf interface example.JPG
plz get back asap mate its quite urgent
tanzzzz :) :)
 

Not sure if it's your problem, but in breadboard I don't see chips connected to ground like in diagram.
 
dude, you can not do a 433 MHz board on a protoboard like that! It will NEVER work.

Breadboard one up on FR4 board instead, something with a ground plane on the back is preferred
 
DSCN0011.JPG
yea tried grounding them, bt the problem become exactly the reverse i dont get any sort of output irrespective to switches

- - - Updated - - -

biff44 sorry dude cudnt get you, i just tried it on a breadboard & not on a protoboard
 

Aravindh RS said:
biff44 sorry dude cudnt get you, i just tried it on a breadboard & not on a protoboard
Click to expand...

Biff's telling you that you cannot use the breadboard like you have done
you need to use PCB .... you will have to etch a board abd mount the components
433MHz isnt likely to work on one of those breadboards ( anything over ~ 100MHz would be bad let alone 433MHz)

you cannot have all those long lengths of wire links at 433MHz

Dave
 
Venkadesh_M said:
Is that a cross connection between the power lines??
View attachment 97359
Click to expand...

nope. just extended the supply through the bread board.. its just that the power and grnd lines were interchanged in the second half of the bread board

- - - Updated - - -

tanx Dave didnt know that... bt tried it in BB because saw videos were people had done this in breadboard
so is it that the lengthy wires are an hindrance to the Tx ???

- - - Updated - - -

THANK YOU SO MUCH GUYYZZZZ its working fine :) :) :)
jst found the mistake, was so stupid, didnt power the decoder :-D
tanks for ur time peeps :)
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top