Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I tried tvf::SETLAYER and tvf OUTLAYER commands, but are not working because creating polygon is not an layer assignment operation.
could u please help me in this.
Regards,
JK
HI All,
I am writing one DRC deck with few rule set for my personal use.
I would like to execute some set of commands repeatedly in caliber. How can I do this?. As calibre does n't support loop statements, How can I perform this loop operation in calibre?
please help me to cross this hurdle...
Hi all,
I want write a small svrf rule file
Could u please tel me which comand to change the metal1 drawing text layer to m1 lable layer, I will give gds as a input to the rule file, I want to get back the out put file in gds,
could you please tell me,
while doing autorout in cadence VCAR, I found some terms like COST and TAX what are these?
What's the meaning of these?
Could u please explain me in detail?
Thanks in Advance
Re: lef import
I used this below comand, but i am unable to import the lef
LefIn -o lef4 -log err -cellList CC0P8500LDO65LP CC0P8500LDO65LP.lef -pinText -H 10 -pinTextLayer M3 drawing
later i imported the lef from GUI, from the generated log file I found the below comand
LefIn -64 -o...
Could u please tell me
How to get the lables for the pins in importing the lef into laker tool through linux comand prompt?
I am susceefully importing the lef in laker with out -pinText, so that i am able to get the layout for given lef with out lables
but when ever i am trying to give the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.