Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
i think your old mosfet is short try a new one... or connect a resistor 10k with gate and other terminal of reistor is connect to ground ...... ur problem will solve ....
i got it when u connect led matrix led get dim
...becoz led are current operated component .......
when u connect power supply to ur ckt all the current used by controller there is no enough current in ur ckt for drive led matrix .......
there is only two solution u have to...
if i used a two charger output connected in parallel
then voltage same current increase it is possible or not.......
and if i connects 5v 2amp to microcontroller what happen then what happens ......damage or not....
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.