Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I want t interface dspic 30f2010 to the LAN. I found out that ENC28J60 is a good solution. But i dnt have an idea about it. Does someone guide me through this? How should I program ENC28J60? can someone provide me any sample codes in mikroc?
It will be a great help for mee
stepper motor controller
hi,
I have 2 stepper motors to be controlled by dspic. I have programmed the pic. Im confused in usng L298 s. Can someone help me with a circuit diagram for stepper motor controller?
How can I implement micro stepping in it? what ic can I use for microstepping. If...
Hi All, I have designed a dspic30f2010 controlled stepper motor controller. I have to interface it to a Internet server, over the ethernet. How can i do it?
Do I need any serial to ethernet converter?
please cn smone help me
Can someone help me out with the scematic of the motor controller with PIC18f4331, l298 and a quadrature encoder. I already implemented the motor controller with a pic 16f877a, but later I had to abandon that idea as 16f doesnt support quadrature encoder modules.. I adjusted the 16f circuit...
I would be glad if someone could help me urgently with this circuit.. I get a output of 9v between output 1 & 2 in the L298 motor controller without connecting the motor. But as soon as I connect the motor the voltage across output 1& 2 drops to 0v. So the motor doesn't work. Im new to motor...
quadrature encoder
Iv made a motor controller circuit for 2 motors & each has a quadrature encoder. The pic im using is pic16f877a. I got no idea regrading how im going to programme the pic to accommodate the encoders.
Herewith I have attached the motor controller programme with the encoder...
pic encoder controller motor
hi thanks for the note. Im finding it difficult to code the scenari as im new to pic programming... Do u hv any sample codes to insert the encoders. I have written the code in mikroc for the pwm functions and taken the encoder signals, but dont hv an idea , hw to...
motoren met encoder schema
hi, thnaks for the help. Now iv started programming pic16f877a. Does that pic have a quadrature encoder module? if it doesnt hv, hw can I get feedback fr a encoder? can some one please help me out with this
dc motor speed control with pic16f877
this code is in ccs isnt it? im not good at ccs. can this be implemented in mikroc? can you provide a sample code in mikroc, for a pic16f877a motorcontroller with a encoder
Added after 2 minutes:
can you provide the same sample code in mikroc?
microc codes for dc motor
hi, i have to build a dc motor controller with a quadrature encoder, which is going to be used to automate a telescope.I thought of using pic16f877a. im new to microc codings. can some one help me out to programme this pic, is there any place to learn the syntax in...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.