Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: problem
hello
thanks alot
first I make (compile,synt,build)by protel DXP and then programming IC with Ise software (impact) and when programming is finished,computer give this message " programming successful". but hardware don't work.
I don't Know what problem it is.
please help me
hello
I have a problem about programming Xilinx.
I program IC Spartan 2 (xc2s150-5pq208) but my program don't run on hardware at all.
even first test that generated a pulse on a pin. the pin always remain 1
I don't know what problem it is.
please help help help me
hello
My project is fifo by fpga
it must do with protel DXP. I used tsk51a_d and made vhdl program .
while hardware connect to pc by Jtag but the software(protel DXP) don't identify.
of course fpga IC is Spartan2 (xc2s150-)
even edif , syn , place, map are generated.
What do I do?
please help me
"Done pin didn't get high" error when programming Spartan 2 in slave serial mode
hello
Do somebody help me ?
My problem is about programing Xilinx Spartan 2 (xc2s150 )
I program it by ISE 6.3 software
when it's programming in mode slave serial,give a error massage.
Done pin didn't get high...
tsk51 design
hello
My project is "design FIFO by FPGA" . I must work by "DXP Protel " . I used TSK51 in my design.Now I want to write C program . This program is following :
1- inter Data by Keypad 4*4 in Write mode
2- display data on LCD in read mode
please help me
thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
