Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi ftsolutions,
Thanks for your advises BUT i do not understand your given solution steps, may you repeat with more detail on how to do it ?
I believe will be solve the problem if able to locate and remove the unwanted object.
Thanks.
- - - Updated - - -
OPS.....
I'm able to remove the...
Hi Mattylad,
Thank you very much your given method, the problem resolved.
By the way, any way to remove the brown outline shown in B?
The real board outline suppose only is the pink color as shown in outline A.
Thanks.
Hi,
Need Altium expertise help on this issue.
Shown in “CAMtastic.Cam” as picture.
https://obrazki.elektroda.pl/63_1305293812.jpg
Why section A (pink color) alignment not same as section B (brown color)?
Section A seem like a mirror view (flip the board) from bottom, how come it happen...
Hi loosemoose,
First picture, it not allow to drag the trace to the pad due to every pad outline got solder mask protected.
Second picture after force to set the net of the trace to GND, then it become like that, my worries is how to confirm it already connected to GND?
Thanks.
Hi,
Need advises from any Altium expert, please refer attached for the questions.
or
https://obrazki.elektroda.pl/89_1304642133.jpg
https://obrazki.elektroda.pl/44_1304642133.jpg
Thanks.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.