Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I created an IP using the create and import IP wizard and connecte dit to the FSL bus. The FSL bus was connected to power PC 405using the PLB2FSL bridge. To begin if every thing is fine I included the default example in the drivers folder of my IP. The name of the IP is adder_1. Every works fine...
Pl. can somebody tell me any way or software for conversion of .hfss file to Gerber format for Fabrication.............I need to know it early since this is a part of my Final year projecti.e. (Design, fabrication and characterization of multilayer microstrip patch antenna for gain enhancement)...
Sorry to disturb u again but I have some confusion,
In the tutorials it is written that the wave port size should not exceed lambda/2 in any dimension but also its width should not be less than 3(2g+w).
In my case I have lambda=25mm
g=0.23mm
w=8mm , all these for Zo=50 ohms.
Now my...
exitar una cpw hfss
Hi guys , In the tutorials it is written that the wave port size should not exceed lambda/2 in any dimension but also its width should not be less than 3(2g+w).
In my case I have lambda=25mm
g=0.23mm
w=8mm , all these for Zo=50 ohms.
Now my waveport width comes out to be...
THANKS a lot shameemkabir,
If u can send me the HFSS 10.0 file ,I can have a better look. Dont worry I have got HFSS 10 installed also.
By the way I also moved the waveport a little down. but I didnt chnge the integration line and I amgetting quite good results. I amattaching the file for u...
Pl. can anyone indicate that is my design ok or not...I feel that there is problem in assigning the waveport.Although I have designed the waveport according to the rules 4*h and 3*(2g+w).
but i am not getting the results right.
Pl also tell me that if my design for cpw feed line is correct or...
grounded coplanar waveguide design
The download link to "Transmission line design handbook by brian cwadell" is
**broken link removed**
Added after 1 minutes:
Another good book is "Coplanar Waveguide Circuits, Components, and Systems"
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
