Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
ft232 usb to rs232
On the question can the FT2232 configures as a host.
Not as far as I know, you need to get a dedicated USB host
to SPI/I2C controller that you can attach to your MPU
Take a look at the FTDI Vinculum USB Host Controller Device.
lmd18245 alternative
You could try the national LMD18245 3A, 55V DMOS Full-Bridge Motor Driver.
Look at h**p://www.embeddedtronics.com/computers.html for stepper
driver board.
atmega8 interrupt
Compiled C code reflected that Timer1 overflow interrupt vector address
was mapped to address 0x10 whereas the datasheet places the vector at 0x08. Downloading the code to the target M8 confirmed that the timer overflow int was not serviced. The header file iom8.h has the ovr1...
The Term full duplex means that there is, or can be concurrent transmission and reception at any station. Async.. means that transmission can start at any time. There is no synchronization between the two stations.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
