Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I have 3phase line in my house
The wire used in the main board are
R phase 4sqmm
Y phase 4sqmm
B phase 4 sqmm
Neutral 4 sqmm
All my loads are single phase
For example in R phase I have 10 amps load
In Y phase I have 8 Amps load
In B phase I have 5 Amps load
Since the loads are single phase the...
dear sir,
in file d1 the pins 13 and 25 is mentioned as GND
in file d2 the pins 13 and 25 are connected to 0v of 24v smps.
my doubt is the pins 13 and 25 must be connected to 0v of smps, are to power ground(earth)
is connecting the pins to smps 0v is correct? both plc and servo...
at what maximum input voltage the microcontroller reads as 0
and at what minimum input voltage it reads as 1
I am using 3.3v microcontroller (dspic33ep512mu810)
I searched the data sheet but i cannot find it
please help me out
i am using dspic33ep512mu810 micro controller it operates at 3.3v vcc
i am interfacing this microcontroller with am26ls31 line driver ic that operates in 5v vcc
the input to the line driver is 3.3v microcontroller the output of am26ls31 is 5v
in the datasheet of am26ls31 says that it accepts...
I am using dspic microcontroller with i2c eeprom. I need large capacity memory say 2048x8 bites. Is there any module that can write in pen drive using i2c are uart communication.
char gps_buf[]={"GPGGA,000044.262,,,,,0,0,,,M,,M,,*4E"};
in the array the last 2 characters is the check sum value ( 4E)
HOW CAN I CONVERT THE LAST 2 CHARACTERS TO DECIMAL VALUE
FOR EXAMPLE
CHAR CHECK_SUM[3]={0}
CHECK_SUM[0]='4';
CHECK_SUM[1]='E';
HOW TO CONVERT THIS TO DECIMAL VALUE THAT IS...
I have 5.5v 1 farad super capacitors
I must get a 5sec back up time after power cut.
I am using a 24v smps my load is a HMI device it operates from 12 to 24v dc operating current is 500ma max at 12v
How can I connect the 5.5v 1farad capacitor to my smps how much capacitors and what connection I...
I am having a 24v smps with 3 amps current rating. If power is off i need a backup time of 5 sec with 1 amps current rating.
what capacitor can i add any circuit available kindly help.
i have decoded the first 2 response but unable to decode the third floating point response
i am using weintek hmi heare is some more response examples
Rx:000001-01 03 04 (4F 80 47 C3) 9E AE =99999.000
Rx:000003-01 03 04( 44 9C C2 6A )FF A2 = -58.567
Rx:000005-01 03 04 (33 33 41 43) 74 D9 =...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
