Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi seadolphine2000 ,
i will try to change the antenna afterward....thx for advise...^^
Hi crazy_enginner,
i am using cytron product 315MHz RF module....
Hi all,
I am a final year student and i am using cytron product 315MHz transmitter and receiver and 2400 baud rate to proceed my final year project. I am also using PIC16F877A in this project.
The problem i face is...
- In the part of transmitter is fine, it i will continuous sent signal...i...
Hi,
Thank for your sharing.
I want to ask about arrangement for pin number. Let say now i have a pic16f877A.OLB for my ORCAD, but the pin number arrangement is does not match the data sheet of this pic, that mean a real pic have a nice sequence arrangement of pin number such as...
Hi all,
Is there any foorprint for RF module (315Mhz transmitter and receiver [3pin]), crystal 20MHz, adapter socket and programmer M05x2 SHD that have been done by you all?
If can please share to me, thank you in advance!^^
Hi all,
I am new in orcad design and I am using Orcad Release 9.1 version now.
I want to ask about how can i to check whether this component such as adapter socket has footprint or not in the orcad library or i have to create a new footprint for it?
Let say i am drawing the schematic circuit...
Sir, please help me again. I am rushing my project now, but I am really cannot do well in the programming side, i have try and try and try but its still cannot get the result i want.
I am really appreciate your helping.
In you transmitter side program ,there is no code for reading your key(porta).QUOTE]
Dear,
Erm i am not actually get it. Can u show me about this?
Thank in advance~
Hi friend,
Erm, my final result of the simulation is the string displayed on the LCD automatically with the sequence or condition i have been write in code (correctly) but without pressed the button at transmitter side.
Here is my simulation circuit.
Thank in advance~!
This is my...
Hi friend,
Yup! I have tried the receiver side by connect the Rx pin on receiver side to a button, and when i press 1 by 1 and the string will show out 1 by 1. So I think this is correct already. That mean once got input then can work as the condition i want.
I have do a simple experiment by...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.