Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hdmi datarate calculation
its 340 MPixels/Sec
In one Pixel 10 bits are transfered.
So its 340 * 10 = 3400 Mbits/S for one channel
For 3 channel it will be 3400 * 3 = 10200 Mbits/Sec = 10.2 Gbps
I hope this clarifies your doubt.
Re: verification enviroment
Making an environment which makes the verification easy.
It will contain generator [ to generate the data either direct or random]
BFM [Bus functional Model] -> this will drive the data to DUT
Monitor -> this will collect all data, check for the protocol and also...
site:www.edaboard.com specman
specman eRM document and sat training material is more than enough.
I would suggest after the basic training, try to make a basic eVC that may clear your all doubts as you check on eanalyzer for the eVC compliant
serial level converter max232
RS232 has nothing to deal with CMOS logic.
For RS232 standard, logic 1 represents -1.5 to -25v (typical -12 v)
logic 0 represents 1.5v to 25v (typical 12v)
Now, you might have used MOSFET and all but MAX232 does only level translator and there are other ICs are...
keypad interfacing microcontroller
Can you show how much work have you done or where you are getting problem exactly ?
Refer Ayala. I think similar example is given and well explained
Re: Regarding ModelSim
it is the file which contains the initial condition values...
vhdl, verilog version used
project settings, all the library file locations used...
it may be work, unisim, simprim etc..
we can change and add on our requirements..that any logical library we can map by...
hi,
i got remainder and quotient individually using SRT division...
now, i need to combine them to make a floating point number
is there any good method for it...
i have tried for dividing the remainder by the denominator for N time ( N is length of the remainder).... but this takes too many...
reading a 4x4 matrix keypad
there are two tasks
1. read the key
2. set output on LCD
first can be easily done with proper key at any of the ports and nand all of then to generate the intrrupt...
the second one can be dependent on the type of LCD you are using...
generally depending upon the...
try to learn any one of the op-amp
the list is already listed by collegue
better understanding will help a lot to make analog circuit on software like orcad, multisim etc...
applications are not to be counted here they are a lot
so try to understand once and see diff op-amps for diff applications
list is as follow but may be continue to infinity
1.there may be comparision between the languages
2. Function, pointer, array, structure...etc base on C
3. Code for simple matrix multiplication, addition etc for DSP base companies
4. Dynamic memory allocation
Indians can refer "Test Your C...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
