Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello DPach,
First idea is to use a Moog type servo valve. Please see:
https://www.moog.com/literature/ICD/Valves-Introduction.pdf
Hope this helps and best regards!
Hello roolit,
Two usual ways to do that is to use either:
1.- Screw an nut to convert rotating movement into linear. The screw may be a recirculating ball type or a standard one. You must decide considering tolerable linear play, need of "reversibilty" in the sense that you can control load...
Hello mrsession,
Please consider that if you have a 40A initial current, you'll see the same current under stalled rotor conditions. Maybe you can design a H bridge with less than 50A transistors but then you have to be very carefull in the design of current limiting system.
Hope this helps...
Thanks you very much!
I laughed all the time!
The guy with long nails is particularly incompetent and should be banned to use any kind of tool.
Regards!
Hello madie01,
I see too many potential failure points in your scheme...
Why not unlock doors by direct hardwired connection in event of smoke/fire detection?
Regards
Re: make fire...
Hello,
I would not think that is not possible, but you should understand that maybe you are not getting answers because the possibly evil uses of a solution.
Regards
Hello,
Dont worry. Anyway, a normal transformer would saturate because you are talking about a signal with a considerable DC component...
Have you heard about resistive dividers? They are also called potencial dividers. The best of them is that you can configure them to reduce voltage to any...
Hello kashif22041,
Without a name plate, it would be a bit dificult to determine that motor parameters.
I assume that you have searched for a similar motor in the Bühler website, and not found your exact model. Rigth?
First, try to compare your motor with the ones in www.buehlermotor.com and...
Hello kotis,
Although what you said is correct, I would forget all about forces, pressures and material resistance related to bucket design.
Buckets have the shape they have because it is easier to pile up, requering less space.
Plastic buckets, as said, have the aditional constrain of easy...
Hello hsprao,
What about your input conditioning circuit? I mean: do you have resistors from input pins to gnd? You`ll need relatively low impedance to ground as a to avoid collecting noise. You can also try a low pass filter adding an aditional resistor and a capacitor to gnd.
Please also...
Hello kender,
Rigid cables will help a lot.
If you need a flexible cable you may need to consider triboelectric charge generated during flexing.
Regards!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
