Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Ferranti Effect, where receiving end voltage is relatively larger than sending end, is more probable in transmission lines, when there is sudden drop of load. The sending end voltage is a bit higher than that with load at the receiving end. Will this phenomenon affect the armature of the...
Please help...
Please help me with this given scenario..
1. 14.4kV : 120/240 V transformer is banked Y-Delta.
2. It provides the following secondary voltage to different loads:
a. 230 V 1-phase
b. 230 V 3-phase
The proposed set-up for the system is to convert Y-Delta to Y (grounded) -...
Good am..
we are currently using 14400 : 120/240 transformer with Y-delta bank.. now we are to reconfigure it to Y ground - Y ground bank.. what are the possible ways to provide 240 volt 3-phase power to a load if we are to use same transformer for the said Y g-Y g bank??? thanks..
pls...
wye delta banks
Thank you so much.. I would just like to confirm, therefore, if it is rewired to wye-delta bank, IT WILL HAVE THE SAME PERCENT IMPEDANCE VALUE..
actually, I have solved mathematically and it came out to be the same whether delta-wye or wye-delta banked transformers.. however, i...
delta delta wye delta
Hi, i would like to ask what will happen to the PERCENT IMPEDANCE of a three-phase transformer having original bank of DELTA-WYE if this is REWIRED to WYE-DELTA Bank?
Will it increase, decrease, or the same value as before?
pls help.. Thanks..u
Re: Can anyone help please?
In that case, heat formula Q = mC(dt) is our main equation to be used.
where Q = heat energy, also expressed as Power*time
m = mass
C = specific heat value of the material to be heated
dt = change of temperature
from the standard...
wye delta
Hi, i would like to ask what will happen to the PERCENT IMPEDANCE of a three-phase transformer having original bank of DELTA-WYE if this is REWIRED to WYE-DELTA Bank?
Will it increase, decrease, or the same value as before?
pls help.. Thanks..u
power factor energy saver
Good evening Mr. Kral:
Thank you for the help..
I would just to ask for a follow-up question:
If the load(let's say 69 KW) with increased power factor of 0.95 from an initial power factor of 0.40, is connected to the system combined with other loads...
Can this...
I would just like to ask how the magnitude of current affect the kW-hr meter reading?
Given this scenario, increasing the power factor of a certain load (for example, 40-watt fluorescent lamp with initial power factor of about 0.40 lagging) to 0.90 lagging, how can this increase of power...
how to increase power factor
I would just like to ask how the magnitude of current affect the kW-hr meter reading?
Given this scenario, increasing the power factor of a certain load (for example, 40-watt fluorescent lamp with initial power factor of about 0.40 lagging) to 0.90 lagging, how can...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.