Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi
What is the use of Rx Threshold value in NS2 ? Is there any relation between Rx Threshold and RSSI value to estimate the distance between two sensor nodes ????
Hi,
I need to find the RSSI level of my WSN node.Is there any possibility
to find it using ns2 simulation? I want to know the ns2 supports RSSI (Received Signal Strength) . If any one knows kindly share with me.
Thanks in advances
Hi,
If any one have idea how to use gennet tool in matlab. This tool available in the version of matlab 2008a.
In other versions this tool is not available. is it possible to get the tool in internet and integrate in the
other version ??? if anyone have the idea kindly share with me.
Thanks
G...
Hi
I am using nrf24L01 transceiver in my wsn node.In this transceiver there is no support for RSSI. In this case, is there any method to find the distance between two wsn node ?Is there any scheme like TOF (Time of Flight) will be useful or not. Pls suggest your opinion.
Thanks
G Kannan
Hi
I am using nrf24L01 transceiver in my wsn node.In this transceiver there is no support for RSSI. In this case, is there any method to find the distance between two wsn node ?Is there any scheme like TOF (Time of Flight) will be useful or not. Pls suggest your opinion.
Thanks
G Kannan
Hi
can any one differentiate the following terms in Microcontroller
Active mode, Idle mode , Stand by mode , sleep mode , power down mode and low power mode...
I have a confusion in these terms .. pls help me if any one knows...
Thanks
Hi,
I need to find the current consumption of MSP430 when the processor enter in the different low power operating mode like
AM, LPM0 to LPM4. and also i need what may be the situation the processor can go to the different low power operating mode.
Pls share the information if anybody work in...
I want to cover only small area like upto 100 meters i.e my sensor node will communicate with each node depending on the distance between the nodes...
also based on the distance transceiver will change the frequency ...
thats why i want wide operating frequency in transciever....
pls reply my...
Hi,
If anyone working with transceiver whose frequency is linearly variable by varying the power. If yes pls tell me the name of the chip and where can i get the same.
Thanks in advance
G Kannan
Hi,
Is there any transceiver available in the market whose frequency can be varied depending upon the application.....pls tell me the name of the chip.
mailid : lg.kannan@gmail.com
Thanks
G Kannan
Hi
if anybody knows how to install and how to utilize the prowler simulator for the wsn application pls share with me.
my mail id : lg.kannan@gmail.com
Thanks
G kannan
Hi
normally the radios use the energy while it txt or rxv any data.. remaining time it may be off.
it can be implemented by power management algorithm either in kernel or application level
Hi ,
I am started doing the research work based on wireless sensor network. in which i am concentrating at node level. is there any tool available to know and change the properties of the sensor node.so that i am able to improve the lifetime / enhance the performance of the sensor network.
can...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
