Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Yes..I have connected in Independent mode.they work independently as separate units.therefore connected in series to increase the Vin to 62V..but why it shifts to CC mode, Its not clear to me.
In my case I have connected 2 Power supplies in series (31V max of each) making 62V total Vin.
at some stage/some times while increasing the Vin after 31V, CC mode LED turns ON and Vin remains constant at 31Vin.The point 2 is marked in attached image whose CC LED turns ON.
Hi,
what does C.C (Constant Current) mode of power supply means..when C.C mode is "ON"/Active, the power supply doesn't provide voltage any more as it stays on fixed voltage.
Can any one explain it clear.
Thanks
Hi,
I am working on DC-DC Flyback converter and have been facing a serious problem of MOSFET failure due to over heating.My desire task is to achieve output Power in range of minimum 20W-30W at-least.
But in range of 5 to 8W Max of power (both in and out), MOSFET starts heating that causes...
My Vgs is 12Vpp.Supply voltage to drive gate driver is taken as 10V.
- - - Updated - - -
Yeah..I have used snubber circuit.Currently using RC snubber(RC in series).
Hi,
This is my first post.I am working on Flyback converter and using MOSFET "IPL60R385CP" in my circuit. The problem is, MOSFET blows up mostly after reaching to the current value of 300mA and current rushes to 2A after breaking the break down region.However Breakdown voltage for the mentioned...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
