Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Sir,
Thanks for your reply,
In my program, the value '27' is stored in array[0],
If i command ,
UART1_Write_Text(array[0]); // I get the output as '27'
UART1_Write(array[0]); // I get the out put '!' which is the ascii char value of '33'(I hope its the address)..
I want the output of...
Hi all,
I am new to Mikroc, For my project, i want to send the character of the decimal value via usart....
For eg:
In ASCII TABLE
Dec Char
22 SYN
27 ESC
32...
Hi all,
I am new to mikroC, I need some help for my project......
My project is to read a text file from a sd card and send it via uart through pic....
I have completed the project in mikroC, and the pic is able to read each byte from the file and send it via uart... by using the command...
Hi all,
I have a very basic question. Can a Clamp meter measure current from a coaxial cable which has two conductors?
If no, is there any other instrument like clamp meter which can measure current in a coaxial cable
Hi all,
I am doing an RF project, I want to know how to prototype rf circuits, as Bread board cannot be used. I am using components which works upto 2ghz.
Anyone Help..
Sir,
Thank you, for your quick reply, i understood the concept, i need a doubt to be clarified,
1. Considering the Sampling frequency, it should be taken twice that of the highest frequency, but in one website it was given that the sampling frequency should be the twice of bandwith used...
Hi all,
In my project, I need to generate sweep signals for the frequency range for GSM bands ie. 890-960Mhz and 1710-1860Mhz.
1. How to generate sweep signals for the above frequency range ?
2. Can it be generated for the above frequency or should i generate sweep signal for 2ghz and...
Thanks for your reply,
I checked those links, but they are of freq ranges above 1ghz. Sorry for not mentioning in the post, I want to generate 2ghz signal and view the freq range of the GSM band i.e. 890-960mhz and 1710-1860mhz. Could you please help me in this one?
1. Is it possible to...
Hi all,
For my project, I need to generate 2Ghz signal. I cant find any oscillator IC for 2ghz.
1. Is there any osc IC for 2Ghz?
2. If its not available can i use 1ghz osc IC and give it to PLL Freq synthesizer ?
3. Will the above idea produce 2Ghz signal?
4. Is there any other method to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.