omsi
Member level 5
Hello,
I am working on UMC65nm process.I am getting the DFM error as following:
POLY1 gates with width <=0.08um not over TG should be align one direction.
Horizontal direction is preferred.
Can Anyone tell why those gate orientations are asked to follow in horizontal?
Is there any fabricating issue or reason for that?
Please Reply,
Thanks in advance,
Omsi.
I am working on UMC65nm process.I am getting the DFM error as following:
POLY1 gates with width <=0.08um not over TG should be align one direction.
Horizontal direction is preferred.
Can Anyone tell why those gate orientations are asked to follow in horizontal?
Is there any fabricating issue or reason for that?
Please Reply,
Thanks in advance,
Omsi.