Ogbachi
Junior Member level 1
All,
I am working on 2-Phase DC-DC Converter simulation using iSiS 7.8 Proteus Software. The gate driver is unable to drive the circuit. Please assist me to look at the attached simulation to spot where i am getting it wrong.
This is my first time of using this software for circuit simulation....please look at it as a design for beginner.
Many thanks.
Pls Note- the design specifications are as follows:
Input voltage ....35-48V
Output voltage....96v
Output current......100A
5% inductor current ripple
5% output voltage ripple
I am working on 2-Phase DC-DC Converter simulation using iSiS 7.8 Proteus Software. The gate driver is unable to drive the circuit. Please assist me to look at the attached simulation to spot where i am getting it wrong.
This is my first time of using this software for circuit simulation....please look at it as a design for beginner.
Many thanks.
Pls Note- the design specifications are as follows:
Input voltage ....35-48V
Output voltage....96v
Output current......100A
5% inductor current ripple
5% output voltage ripple
Attachments
Last edited: