miskol
Member level 4
Hi,
i've made a mistake in the soldermask design. as shown in the picture, the pads for the SMT tactile switch on the top layer is by mistake also made available for the bottom layer.
1) my question, is there gonna be any problem? in term of high-speed circuitry, is there any significant effect?
2) is there any easy way to repair is? can i ask the Board House for a repair?
3) any other suggestion on what should i do?
Thank you.
i've made a mistake in the soldermask design. as shown in the picture, the pads for the SMT tactile switch on the top layer is by mistake also made available for the bottom layer.
1) my question, is there gonna be any problem? in term of high-speed circuitry, is there any significant effect?
2) is there any easy way to repair is? can i ask the Board House for a repair?
3) any other suggestion on what should i do?
Thank you.