mariomoskis
Member level 1
hello,i am trying to measure a square wave(pwm) with amplitude 3V, so when i try to measure it with a multimeter across my motor,should i watch the next:
Vmultimeter=3*sqrt(duty cyle)
is it correct? because sometimes i am watching more than 3V on my multimeter across the motor about 3.7V but i think that it shouldn´t be higher than 3V.
i think that it can be caused about the inductance of the motor but i try to put a zener diode of 3V at the output of the AO but the problem is still happening.
somebody could help me with that? the Vcc=6V and the multimeter is set between the output of the power operational amplifier and ground
thanks
Vmultimeter=3*sqrt(duty cyle)
is it correct? because sometimes i am watching more than 3V on my multimeter across the motor about 3.7V but i think that it shouldn´t be higher than 3V.
i think that it can be caused about the inductance of the motor but i try to put a zener diode of 3V at the output of the AO but the problem is still happening.
somebody could help me with that? the Vcc=6V and the multimeter is set between the output of the power operational amplifier and ground
thanks