Okada
Banned
I am designing a Weighing Scale and want to use LTC2440. I want to know how to Configure the resolution of the LTC2440 to 24 bit.
In device datasheet page no. 14 table 3 provides the OSRx values to be written to the device using its SDI pin. Should I write 0x08 serially to configure the device to output 24 bit adc result ?
If yes, When should I write this value ? While reading the device ?
In device datasheet page no. 14 table 3 provides the OSRx values to be written to the device using its SDI pin. Should I write 0x08 serially to configure the device to output 24 bit adc result ?
If yes, When should I write this value ? While reading the device ?