Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Is the PCB board material model needed in HFSS?

Status
Not open for further replies.

ssstar

Junior Member level 1
Joined
Oct 13, 2004
Messages
16
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
136
hfss pcb modeling

I want to simulate a patch antenna through HFSS. Do I need to specificate the material of the PCB board which the antenna is attached to? Or I only need to make a 2D model and set the PCB board as condutive boundary?
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top