amaze1
Junior Member level 2
icd2 clone usb
Hi everyone
I just purchased this ICD2 clone from sureelectronics:
**broken link removed**
**broken link removed**
I installed mplab v7.50 (docs says it works well with such release, I planned to upgrade after some tests) and everything was ok.
Without any target board the clone was recognized by the IDE either as debugger or programmer and pass selftest.
Ok, I was happy and went to the dinner
After dinner I prepared myself for the first serious test (program a 16f628 to blink a led) but when connect the clone to usb port (the same usb port I connected it before and always without any target board) the red error led switch on and there is an usb port overload .
Any idea ?
Hi everyone
I just purchased this ICD2 clone from sureelectronics:
**broken link removed**
**broken link removed**
I installed mplab v7.50 (docs says it works well with such release, I planned to upgrade after some tests) and everything was ok.
Without any target board the clone was recognized by the IDE either as debugger or programmer and pass selftest.
Ok, I was happy and went to the dinner
After dinner I prepared myself for the first serious test (program a 16f628 to blink a led) but when connect the clone to usb port (the same usb port I connected it before and always without any target board) the red error led switch on and there is an usb port overload .
Any idea ?