amaze1
Junior Member level 2
Hello to all, sorry for bothering with an old problem.
I have an ICD2 clone from SureElectronics, purchased in 2008.
**broken link removed**
Since first use he shows its tendence to lose 18f4550 firmware.
At first I was able to reprogram it with the Hex file received from Sure Electronics
( see also this thread : )
After 2 years of almost no use of it I decided to re-start and the old trouble come out again, so after looking on SureElectrnics forum here:
**broken link removed**
I ask them to send me such new firmware. They did it but now I receive this error message:
and the ICD2 is not recognized from MPLAB (7.50).
The worst thing now is I am not able to program any other firmware anymore
Any idea ?
I received also a 16F877 hex file. I have to flash it too ? :?:
MazE
I have an ICD2 clone from SureElectronics, purchased in 2008.
**broken link removed**
Since first use he shows its tendence to lose 18f4550 firmware.
At first I was able to reprogram it with the Hex file received from Sure Electronics
( see also this thread : )
After 2 years of almost no use of it I decided to re-start and the old trouble come out again, so after looking on SureElectrnics forum here:
**broken link removed**
I ask them to send me such new firmware. They did it but now I receive this error message:
Code:
PICSTART Plus Firmware Version 04.50.02
Erase operation is successful.
Device is blank.
PICSTART Program\Verify Report
15-Jul-2010, 12:54:04
Device Type: PIC18F4450
Address Range 0-3fff
Configuration Memory Errors
Field : Boot Block Size Select
Expected: 2 KW
Received: 1 KW
and the ICD2 is not recognized from MPLAB (7.50).
The worst thing now is I am not able to program any other firmware anymore
Any idea ?
I received also a 16F877 hex file. I have to flash it too ? :?:
MazE