Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
You are asking about a commercial attenuator IC, custom analog chip design or a discrete attenuator circuit?
In case of the commercial product, you'll derive it from datasheet specifications or need to measure it, in all other cases, you can calculate the errors if you know all circuit parameters, including parasitic elements.
Hi FvM,
Thanks for your reply. I am not using commercial Attenuator IC. I am designing 4-bit digital attenuator. Kindly elaborate this for my understanding. By which method or procedure i can find out RMS Phase and Amplitude errors.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.