TenmaNeko
Newbie level 6
Hello all. I am using Allegro PCB Editor 15.2. I had three GND planes and a power plane created with dynamic copper pours. Naturally, once I created them I turned off their visibility. At some point, when I turned them back on I noticed that the planes were making full contact with vias that they were not electrically connected to. This occurs on each plane in roughly the same area of the board (under a 484-pin bga FPGA), but it is not exactly the same on each layer. Also it is not consistent, as I deleted the dynamic shapes and redrew them to find that generally the problem was the same, but there were a few vias that were different.
So, I have tried running DBDoctor, I have moved the shapes and moved them back, I have deleted them and redrew them, and I have tried drawing voids manually. None have worked.
Does anyone have any more ideas? I'm willing to try about anything to get this to work.
Thanks!
So, I have tried running DBDoctor, I have moved the shapes and moved them back, I have deleted them and redrew them, and I have tried drawing voids manually. None have worked.
Does anyone have any more ideas? I'm willing to try about anything to get this to work.
Thanks!