swakit
Junior Member level 1
I am designing a development board using ATMEGA 32 and also has other IC's like FT232 and a regulator 1117 (5 volts). Many sensors and LCD are still to be connected.
In the board I am getting all the desired voltage levels at all points but still the circuit is not working. Is there any problem with the current flow because when i measured current, it was just 15 mA on entire board. If yes, then how am I supposed to fix it ? Please help
I have used a self made double sided PCB.
In the board I am getting all the desired voltage levels at all points but still the circuit is not working. Is there any problem with the current flow because when i measured current, it was just 15 mA on entire board. If yes, then how am I supposed to fix it ? Please help
I have used a self made double sided PCB.