Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Configuration bits question

Status
Not open for further replies.
T

Thunderhorse312

Member level 1
Joined
May 7, 2012
Messages
32
Helped
0
Reputation
0
Reaction score
1
Trophy points
1,286
Activity points
1,526
what would happen to the microcontroller if the configuration bits are not specified? will it work or not? Also, what would then be the default set up for the config bits?
 

What microcontroller? What configuration bits? Are you expecting us to read your mind?
 

Well, usually they're set to a default value. So, the microcontroller will work, just maybe not as you planned.

You should specify which microcontroller.
 

barry said:
What microcontroller? What configuration bits? Are you expecting us to read your mind?
Click to expand...

Sorry about that.. I'm using PIC16F877A and i was just wondering what would happen if i did not set my configuration bits (i.e. XT HS for oscillator)?
 

If you read the data sheet, it will tell you what the defaults are. Maybe they'll work for your application, maybe not. YOU need to decide that.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top