Hugo17
Junior Member level 1
Following simple question:
When I add a SPI 3-wire serial interface in QSYS I can set several parameters like: Type, clock speed, data width etc..
So why do I need those parameters when I setup the SPI interface directly in VHDL? In other words, are those parameters only
valid when I this interface with a NIOS?
Thanks!
When I add a SPI 3-wire serial interface in QSYS I can set several parameters like: Type, clock speed, data width etc..
So why do I need those parameters when I setup the SPI interface directly in VHDL? In other words, are those parameters only
valid when I this interface with a NIOS?
Thanks!
