Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

why source followers are avoided in low-noise amplification?

Status
Not open for further replies.
W

wholx

Member level 4
Joined
Apr 20, 2005
Messages
76
Helped
4
Reputation
8
Reaction score
0
Trophy points
1,286
Activity points
2,050
Since source followers add noise to the input signal while providing a voltage gain less than unity, they are usually avoided in low-noise amplification.
Click to expand...

Anyone can explain a little more about these words by Razavi (p232, section 7.4.3)? I don't quite get the consequency here.
 

Re: why source followers are avoided in low-noise amplificat

Think of the concept of signal to noise ratio. The source follower increases the noise but not the signal.


There is one restriction to the statement in the book. You can have power gain without any voltage gain if the impedance levels are different.
 

    W

    wholx

    Points: 2
    Helpful Answer Positive Rating
very helpful flatulent.

still, any example for your comment on the case where we have power gain without voltage gain?
 

Re: why source followers are avoided in low-noise amplificat

One example is for a high impedance sensor such as a piezoelectric microphone. Putting this to a source follower which is driving a 100 ohm load causes more signal power in the load than is out of the microphone. (p=v*v/r)
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top