Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

spartan- 3an xc3s700an I/O PINS HELP

Status
Not open for further replies.
A

ANS HAFEEZ

Advanced Member level 4
Joined
Jul 25, 2013
Messages
101
Helped
5
Reputation
10
Reaction score
5
Trophy points
1,298
Location
LAHORE,PAKISTAN
Activity points
1,911
SALAM
I M JUST NEW TO FPGA AND HAVING PROJECT OF MOTOR SPEED CONTROL THROUGH PWM
IN XILINX I SUCCESSFULLY SYNTHESIZE THE VERILOG CODE..

NOW HOW TO INTERFACE FPGA TO OUTER WORLD
I HAVE TO INTERFACE H-BRIDGE WITH FPGA SPARTAN 3AN XCS700
I HAVE DOWNLOADED DATASHEET BUT DID NOT GET HOW TO GIVE INPUT AND GET OUTPUT FROM FPGA
WHICH PINS I HAVE TO CONNECT ??
ANY QUICK HELP???
:oops: spartan-3a-starter-kit.jpg
 

Did you create a UCF for the pin placement of your design? As you have a board you are supposed to run this on, did you get the schematics for the board and determine what pins go to which connectors? If you didn't do this then your pins will be selected by PAR and probably won't match anything on the board.

Regards
 

Next time insert the image using the insert image upload feature of the forum Capture.PNG, I dislike links to picture archives.

I've never used a Spartan 3an starter kit, so I have no clue what that connector is used for. Have you looked at the board documentation. They normally tell you what all the FPGA pins are connected to and which connectors you can make use of. If there is some sort of mictor or a plain old .1" spacing header of the board I would use that.

I suggest you do some reading.

Regards
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top