Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

which port i need to use in thia planar monopole antenna???

Status
Not open for further replies.
S

slteoh

Newbie level 4
Joined
Dec 28, 2010
Messages
6
Helped
2
Reputation
4
Reaction score
1
Trophy points
1,283
Activity points
1,299
**broken link removed** Uploaded with ImageShack.us
anyone know how to simulate this antenna???which port i have to use??

and what is mean by feeding strip??Is it using that for waveport??
 
Last edited by a moderator:

hi deer
for this antenna better u use SMA and for simulation u should use wave port in hfss11
and for more information u can read this book
Broadband Planar Antennas Design and Applications by Zhi Ning Chen and Michael Y. W. Chia
in chapter 5 u can find this antenna and in chapter 3 u can find feeding by microstrip
 
  • Like
Reactions: slteoh

    S

    slteoh

    Points: 2
    Helpful Answer Positive Rating
i am using cst so how to create a sma connector for the simulation.Thanks for ur help!!!
 
  • Like
Reactions: yasap

    Y

    yasap

    Points: 2
    Helpful Answer Positive Rating
hi
create a hole in u antenna ground page with r=1.6 and then design a pin in center of it with r=0.6 and the height of pin h=.5mm(1mm) + H which H the height of u ground page and u pin u been .5mm(1mm) upper than u ground like the fig u attach
 
its work!!!thanks very much
 

    V

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top