Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

how to chnage frequency!!! 433 mhz to 900 mhz

Status
Not open for further replies.
H

hassan siddiqui

Newbie level 3
Joined
Mar 7, 2010
Messages
4
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
pakistan
Activity points
1,303
hi i want to know dat
how can i change the
rf receiver frequency
433 mhz to 900 mhz

thanx in advance
 

You can't change directly because its LNA and mixer ( and apparently PLL )have been optimized for this frequency.But you may use a external mixer-oscillator to downconvert this signal.In this case you should use an LNA that will operate at 900MHz.
 

You may want to mention the receiver you are using. For some popular SRD devices, changing a few components (L and C)
and software register values does the job.
 

LNA == Low Noise Amplifier


As BigBoss said, the 433MHz unit isnt going to work on 900MHz
you need to mix the 900MHz signal with a separate LO (local Oscillator) to produce an IF of 433MHz.
( that is if you insist on using the 433MHz unit)
Else you just build a complete 900MHz receiver


Dave
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top