Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Patch Antenna fabrication step

Status
Not open for further replies.
T

Tot

Member level 1
Joined
May 22, 2007
Messages
33
Helped
4
Reputation
8
Reaction score
3
Trophy points
1,288
Activity points
1,433
antenna fabrication

Dear All,

I have simulated a patch antenna using HFSS V11 the result gave me very good BW and radiation pattern, from here i am new and i have no idea how to start the fabrication, my question is how to layout the simulted patch antenna?


Thank you
 

patch antenna fabrication

my advice is to figure out how you intend to build th e patch and then you can decide how to export the dimensions from HFSS.

A PCB structure is different from a foil and tape and has different demands for example.
 

Hi tot
Import to some file such as .dwg or .iges
And make film/mask from it
As suggested by llololl you can use Orcad if your pcb manufacturer/ Film maker dont accept dwg or .iges etc. then convert your file to .pcb.
 

Dear Tot,

You can export the design into *.dxf file. Then import it in another software as Microwave office. From Microwave office, the imported file will need some boolean manipulations as it will be imported as shapes. Then export to either gerber or pdf depending on the way you will generate the mask.

Best Regards,
Mshafee
 

sorry for asking again,

I have tried what you said but i really couldnt find the right way even the help file doesnt say anything about this.


Can some one please help me on this

I have HFSS V.11.1


Thank you very very much guys
 

you can print out as a pdf in scale and then print to the film or aydinger
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top