Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

i need a help about IP3 and compression 1dB

Status
Not open for further replies.
N

nassim1

Full Member level 4
Joined
Jun 2, 2008
Messages
195
Helped
15
Reputation
30
Reaction score
10
Trophy points
1,298
Activity points
2,515
ip3+ads

I want to calculate and simulate IP3 (input and output) and also compresson 1dB in ADS software.. Is there tutorial in ADS about them?

How can i know my simulation results ? i.e, IP3 is variebal between what and what ??

application for mixer, lna .....


thx a lot in advance

nassim
 

ip3 compression

ADS calls IP3 TOI, Third Order Intercept. TOI and -1dB are done using
Harmonic Balance they should have design guides or examples built in
just look around or use the help.
Good luck
 

third-order intercept point agilent ads

thanx, i will try ........

i do konw if there is an apllication inn the net ??

thx again
 

toi ip3

Hi naasim,

You should use a source RFpower component and haronic balance available in

ADS palette , i attahed file i'll give an example in ADS may will help you.......

Mouloud
 

harmonic balance ads ip3

and this eplanation file...

take care

Mouloud

Added after 1 minutes:

Sorry, it can not send to you html file, so you write this 'Agilent ADS Tutorial (Project 3)' in googl, you will find the html page

Mouloud
 

ip3 and compression

dear colleagues,
Thx so much mouloud08, i will use what you have sent to me ...pls if there is onther explanation or tutorial would you help more again....

nassim
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top