Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Question: How to measure matching?

Status
Not open for further replies.
B

brian39

Newbie level 4
Joined
Jun 15, 2003
Messages
5
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
193
How to measure matching?

There is a matching circuit between SAW filter and LNA on a PCB. when

needs measuring the matching of this circuit . How to measure ? It works

GSM900 band , i think only power to measure after SAW filter and before

LNA with Spectrum Analyzer, is right? Pls give me a correct way.
 

Hi brian39,

To measure the correct matching, you have to use a network analyzer connected after your SAW filter and to measure the S11 parameter.
This gives you the return loss (reflected power) which should be as small as possible (better than -10dB is often OK). The phase information can be used to optimize the matching network.
If you don't use the phase info and you don't have a network analyzer you can also measure the return loss with a directional coupler, a frequency generator and a spectrum analyzer or powermeter.

Bye
 

Thank u !

/ Warning#9 - No thanks at elektroda! /
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top