Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi everybody,
I am controlling DC motor with opto-coupler, my opto-coupler gives correct output i.e. when ther is no obstacle the output is 0volt and when there is an obstacle in between then the output is 5volt.
But as soon as i connect to the P1.1 of 89v51RD2 it sinks all the voltage and...
Use comparator to check the password, if the password does not matches it will make AeqB pin low, now connect the NOT gate at AeqB pin and connect the output of NOT gate to the buzzer.
No, here query is not incomplete, Actually i made the code for keypad from 0-9 which is working properly, but i don't know how to perform these actions like Enter,Del...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.