Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
using analog switch
Is there a simple schematic that use bipolar or fet, mosfet transistors in order to provide analog switch like 4066 i.c. I can use 4066 but i nead only one switch in my circuit and I would rather use something smoler in footprint then whole 4066. It is just a size and...
pickit2 serial analyzer
I found the answer. It is not possible. These two devices are basecly the same. I found the schematic of PicKit2 here
**broken link removed**
and for Serial Analyzer here
**broken link removed**
U can see that there are many, but small, differences. However there is...
pickit serial
Yes, yes I now that. I was asking is it possible that the hardware in these two are the same, look closely, they have inputs on the same pins, because PicKit2 can be used as logice state analyzer, in the tool menue of PicKit2 programmer PC aplication, there is that option, also as...
pickit serial analyzer
Does anybody knows is there hardware difference between these two? Can I use PikKit2 as PicKit Serial Analyzer. I have look user guide but I think that microchip lie pretty much about everything, so maybe the difference is lie too.
Hi, I need wary simple telecommand i any frequency. Only thing that it matters is that there is no pll or any delay element like quartz filters. I need it in one direction so it would be one transmitter and one receiver. It is necessary to delay time from moment i enable transmitter to time i...
eagle smashed pcb
M!k
i think that u didn't understand me, i want that when i do smash, and fix position of names and values do something that will glue them on that new position and to acct like it was that way from the library! So, when i smash it is there, a way to glue it up and lose +...
eagle unsmash
Hi,
when i use smash command and fix place of text how can i unsmash that component to lose + marks on text labels. I thought that shift + smash will do the trick, but when i do that i just go back like i nothing done!!! Is there a solution for this problem?
eagle smash
Hi, i have a question
how can i change dimensions (width) of pads in pcb. When u making library element u really define only inner diameter , but width of that pad depends of design rule of exact board. Where can i find that settings?
Hi, i have a quastione
How can i make text on PCB bottom layer but when adding ground plate i want ground plate to wrap around text with distance like it is defined for distance between two lines. When i make ground plate eagle sets rectangle around text and don't let copper to be placed on...
I need to make myself component. I can make complete component, but i can't find the way to edit existing symbol ieg.
i want to make PIC12F675 from PIC12F629 i need to make some changes. I need to change label of device and label of one pin. How can i do that, i don't want to draw whole symbol...
That are two sites that i have found myself, but they are useless because it is not compleate project. It is not really a logic analyser, they all use development board. I want to make real project.
No, it is misunderstood i don't want to make my CPU, i want to make my logic Analizer with FPGA and some uC. I need URL to sam logic analizer project.
P.S. Thanks on fast reply.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
