I need to deploy small mesh network. my requirements are
* Minimum 802.15.4 MAC should be there.
* Board should have Many GPIO for users.
* Good to have have USB( or UART) interface. (Minimum PAN coordinator should have host interface, remaining can be without host interface)
* Good to have few sensors on board (Not must)
* Low cost
* debugger
* IDE (gcc compiler)
Can anyone suggest any modules?
What is specification used by Nordic RF modules, did they follow IEEE 802.15.4 spec. i have check their products they didn't mentioned IEEE 802.15.4 complaint RF.
if they they are following a different specification, Can you please share more details about this Nordic