Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

xilinx powerpc and altera arm9

Status
Not open for further replies.

bjzhangwn

Member level 1
Joined
Aug 9, 2004
Messages
37
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
306
now I am intered in the embeded system in fpga,and the evaluation board from xilinx and altera is very expensive,can some share your schematic and i want to have an evaluation board done by my self.
 

echo47

Advanced Member level 5
Joined
Apr 7, 2002
Messages
3,942
Helped
636
Reputation
1,270
Reaction score
88
Trophy points
1,328
Location
USA
Activity points
33,183
xilinx powerpc and @ltera arm9

What are your requirements?

You can put a lot of stuff into the low cost boards available from several manufacturers. The Xilinx/Digilent Spartan-3 board is only $99 US.

Here's a good list:
http://www.fpga-faq.org/FPGA_Boards.shtml
 

bjzhangwn

Member level 1
Joined
Aug 9, 2004
Messages
37
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
306
xilinx powerpc and @ltera arm9

now,I have no idea which fpga shoud i choose,alter or xilinx.I want a pci-e in the fpga and also a embeded system ,can some give some advice ,about the price and the performence!
 

mwmmboy

Full Member level 2
Joined
May 18, 2001
Messages
136
Helped
8
Reputation
16
Reaction score
2
Trophy points
1,298
Activity points
978
If you want to have a your own evaluation board it is quite simple..Choose a device and then design the bias circuitry, an oscillator and then place all output on connectors. That's all.
In the datashèet of the devices you can find suggestion on biasing and also some IC to use for the power supply.
I think you can use evaluation license for the development tools to test the embedded soft processors and other IP.

Hope this can help.

Added after 1 minutes:

If you want to have a your own evaluation board it is quite simple..Choose a device and then design the bias circuitry, an oscillator and then place all output on connectors. That's all.
In the datashèet of the devices you can find suggestion on biasing and also some IC to use for the power supply.
I think you can use evaluation license for the development tools to test the embedded soft processors and other IP.

Hope this can help.
 

Status
Not open for further replies.
Toggle Sidebar

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top