lalani2009
Newbie level 4
Hello to all,
I am using XBee RF modules in my project. For testing I have made simple code in code vision AVR for ATmega32 microcontroller. In which one as transmitter and another one as receiver. Transmitter sends only single byte as '1' or '0' continuously at every 2 seconds and at receiver side if received byte is '1' than LED on and if it is '0' than LED off.
But problem is that code at transmitter side runs properly but receiver does not give any response.So please help me to solve this problem.
I have attached both Tx and Rx code with this post.
I am using XBee RF modules in my project. For testing I have made simple code in code vision AVR for ATmega32 microcontroller. In which one as transmitter and another one as receiver. Transmitter sends only single byte as '1' or '0' continuously at every 2 seconds and at receiver side if received byte is '1' than LED on and if it is '0' than LED off.
But problem is that code at transmitter side runs properly but receiver does not give any response.So please help me to solve this problem.
I have attached both Tx and Rx code with this post.