vipinlal
Full Member level 6
Hi guys,
I have a designed a module which outputs a single bit in each clock cycle.I want this module to run for sufficiently long time and process the data later using some other software.I want something like writing the output data into a text file in PC connected to the board. Ho do I do this?
I am not talking about simulation here.I want the code to run in real time on a fpga board.
Any suggestions are welcome. If there are standard programs available for this online then please post the link also.
I just searched in net.And I found that I can use RS232 port available on the spartan-3A starter kit board.But I dont know how to use it. Can somone write a step by step procedure for this?
thanks,
vipin
I have a designed a module which outputs a single bit in each clock cycle.I want this module to run for sufficiently long time and process the data later using some other software.I want something like writing the output data into a text file in PC connected to the board. Ho do I do this?
I am not talking about simulation here.I want the code to run in real time on a fpga board.
Any suggestions are welcome. If there are standard programs available for this online then please post the link also.
I just searched in net.And I found that I can use RS232 port available on the spartan-3A starter kit board.But I dont know how to use it. Can somone write a step by step procedure for this?
thanks,
vipin