wireless robot controller
Dear All,
For this wireless Robot control system, I hope use high level computer language like as C, C++, VB..etc. to control full system, the system will seperate into serveral parts, like as 1. circuit hardware, 2. control software, 3. monitor software,
circuit hardware included main CPU , Sensor, Motor driver, wireless and mechanical architecture,
I could offer a hardware architecture connect with ethernet and anybody may use your own software to control it via TCP/IP or wireless through TCP/IP to RF-Link (RS-232C).
Added after 8 minutes:
This application just for study and research,
no limit and condition if you just like to study it.
First, need to know 8051 CPU hardware or C language, And could run on Keil C IDE envinentment if you have a 8051 hardware and software.
Added after 2 minutes:
If you using VLSI like as CPLD or FPGA chip then you need to know Verilog or VHDL language,
Then you may design a hardware / software to control it .
Added after 3 minutes:
If you do not know hardware nor software,
one is study it right now or just look people do it.
have a fun or have a joke.
Added after 5 minutes:
To know 8051 CPU, first you need to get a set of
8051 CPU, You may get a free samples from CPU manufactures like as Silicon Lab. Inc.
[
https://www.silabs.com/pages/default.aspx ].
Also may download the IDE debug tools too.
You also need to know C language, find a book or
website which discussion about C language.
Added after 3 minutes:
After that you have prepare the hardware or software capability then we may discussion which
part of system you are interesting.
Added after 2 minutes:
For host equipment like as PC/AT system, You need to know C/C++ language, TCP/IP, RS-232C port., GUI....